Pre- and post-processing of joining processes

© Fraunhofer IPA

The quality of a joint is determined not only by the joining process itself but also by the upstream and downstream process steps. To ensure optimal joint performance, it is essential to understand how these steps influence the final outcome.

Thanks to our broad expertise and extensive research, we can provide you with comprehensive support in analyzing and optimizing these critical process stages.

 

Case Study – dry ice blasting technology for cleaning

Dry ice blasting is an innovative compressed air blasting process that efficiently removes contaminants such as grease, soot, and dust from various material surfaces. The process uses CO₂ snow as the blasting medium, which sublimates instantly upon contact, leaving no residue. This makes it particularly suitable for adhesive bonding surface preparation.

 

Case Study – Surface Pre-Treatment with Laser Technology

Adhesive bonding requires exceptionally clean and mechanically optimized surfaces. With very hard materials, conventional methods such as grit blasting or grinding often reach their limits. We therefore investigate laser-based surface pre-treatment techniques, which allow for reproducible, hardness-independent, and highly controlled surface modification.

 

© Fraunhofer IPA
Vibratory finishing as surface refinement

What we offer

Feasibility studies

We assess the suitability of new technologies for your production line. Based on your requirements, we conduct tailored feasibility studies to evaluate potential solutions.

Workshops and Consulting

Not sure which pre- or post-processing method is suitable for your joining processes? Or looking for an up-to-date expert assessment? We are happy to advise you.

Individual Process Development and Optimization

Need support developing or further improving your process? With our extensive expertise and years of experience, we design and optimize processes tailored to your needs.